If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 85.Installing the virtual media keyTo install the virtual media key, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 46.2. Remove the cover (see “Removing the cover” on page 49).3. Align the virtual media key with the mounting tab and slide it down the tab ontothe connector on the system board. Press the virtual media key down into theconnector until it is firmly seated on the system board.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 85.Installing a USB embedded hypervisor flash deviceTo install a hypervisor flash device, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 46.2. Turn off the server and peripheral devices and disconnect the power cords.3. Remove the cover (see “Removing the cover” on page 49).4. Align the flash device with the connector on the SAS/SATA RAID riser-cardassembly and push it into the connector until it is firmly seated.5. Slide the blue lockbar toward the flash device to the locked position until it isseated firmly.80 IBM System x3550 M2 Types 4198 and 7946: Installation and User’s Guide