6. Replace the cover and connect the power cord. See “Replacing the cover andconnecting the cables.”7. Restart the computer, leave it on for approximately 10 seconds. Turn off thecomputer by holding the power switch for approximately 5 seconds. Thecomputer will turn off.8. Repeat steps 2 through 4 on page 22.9. Move the jumper back to the standard (pins 1 and 2).10. Replace the cover and connect the power cord. See “Replacing the cover andconnecting the cables.”Replacing the cover and connecting the cablesAfter working with options, you need to install any removed parts, replace thecover, and reconnect any cables, including telephone lines and power cords. Also,depending on the option that is installed, you might need to confirm the updatedinformation in the IBM Setup Utility program.To replace the cover and connect cables to your computer:1. Ensure that all components have been reassembled correctly and that no toolsor loose screws are left inside your computer.2. Clear any cables that might impede the replacement of the cover.3. Position the cover over the chassis and pivot it down over the computer until itsnaps into place.4. Reconnect the external cables and power cords to the computer. See “Installingexternal options” on page 6.5. To update the configuration, see Chapter 4, “Using the IBM Setup Utilityprogram,” on page 77.Chapter 1. Types 8149, 8177, and 8178 23