4. If necessary, see “Installing adapters” on page 38 to remove any adapters thatimpede access to the Clear CMOS/Recovery jumper.5. Move the jumper from the standard position (pins 1 and 2) to themaintenance or configure position (pins 2 and 3).6. Replace the cover and connect the power cord. See “Replacing the cover andconnecting the cables.”7. Restart the computer, leave it on for approximately 10 seconds. Turn off thecomputer by holding the power switch for approximately 5 seconds. Thecomputer will turn off.8. Repeat steps 2 through 4 on page 47..9. Move the jumper back to the standard (pins 1 and 2).10. Replace the cover and connect the power cord. See “Replacing the cover andconnecting the cables.”Replacing the cover and connecting the cablesAfter working with options, you need to install any removed parts, replace thecover, and reconnect any cables, including telephone lines and power cords. Also,depending on the option that is installed, you might need to confirm the updatedinformation in the IBM Setup Utility program.To replace the cover and connect cables to your computer:1. Ensure that all components have been reassembled correctly and that no toolsor loose screws are left inside your computer.2. Clear any cables that might impede the replacement of the cover.3. Position the cover on the chassis so that the guides on the top and bottom ofthe cover engage the chassis and push the cover to the closed position. Insertthe screws that secure the cover.4. Reconnect the external cables and power cords to the computer. See “Installingexternal options” on page 30.48 User Guide