The following illustration shows the locations of parts on the system board.1 Microprocessor 11 SATA0 connector2 DIMM connector 1 12 Front panel connector3 DIMM connector 2 13 Clear CMOS/Recovery jumper4 DIMM connector 3 14 Battery5 DIMM connector 4 15 Front panel audio connector6 Power connector 16 PCI slot 37 Diskette drive connector 17 PCI slot 28 Primary IDE connector 18 PCI slot 19 Secondary IDE connector 19 AGP slot (some models)10SATA1 connector 20 12v power connectorInstalling memoryYour computer has four connectors for installing dual inline memory modules(DIMMs) that provide up to a maximum of 4.0 GB of system memory.When installing DIMMs, the following rules apply:v System memory is divided into two channels (channel A and B). DIMMconnectors 1 and 2 are channel A, and DIMM connectors 3 and 4 are channel B.v If DIMM connectors 1 and 3 (or 2 and 4) are filled with the same technology andsize of memory, the system operates in dual channel mode.v Use 2.5 V, 184-pin, double data rate synchronous dynamic random accessmemory (DDR SDRAM).v Use 128 MB, 256 MB, 512 MB or 1.0 GB DIMMs in any combination.v DIMMs are 38.1 mm (1.5 inches) in height.Note: Only DDR SDRAM DIMMs can be used.62 User Guide