IBM Aptiva 2142 Hardware Maintenance Service

Also see for Aptiva 2140: Maintenance service manual Hardware maintenance service

(continued)006 (continued)DOES THE HARDWARE CONFIGURATION REPORT CORRECTLYIDENTIFY THE DEVICES INSTALLED IN THE SYSTEM UNIT?Yes No007– The System Configuration Report shows only those devicessupported by the Diagnostics and Utilities CD and onlyfactory-installed devices for the model you are servicing.– If a device is missing from the list and is not factory installed, referto the service manual provided for that device. (Refer to theAppendix B, “Model/Monitor Configurations and FRU Part Numbers”on page B-1 to determine the factory-installed devices in the modelyou are servicing.)– If a factory-installed drive device or adapter card is not listed in theSystem Configuration Report, return to “Start” on page 2-2 and thengo to “Factory-Installed Drive Devices” on page 2-47.008– Select Diagnostics Menu from the Main Menu.– Select Easy Test Diagnostics from the Diagnostics Menu.DOES THE EASY TEST FINISH WITHOUT ERROR CODES?Yes No009– If the last test stops and you cannot continue, first make sure allswitches, power connectors, cables, and jumpers are set correctlyand show the correct voltages and continuity.– Make note of any messages, error codes, beeps, or new symptoms.Go to “Index of Symptoms, Messages, Error Codes, or Beeps” onpage 2-9.010– The Easy Test Diagnostics did not detect a failure. If the system stilldisplay a failure:Check all adapter card jumper settings.Check all adapter card switch settings.Check all adapter card cables and connectors for proper installation.Make sure all of the above are set correctly and show the correctvoltages and continuity. Replace any defective cables or adaptercards. See “Power Supply” on page 2-34, “System Board2-44All manuals and user guides at all-guides.com