310 IBM System Storage N series Hardware Guide4. Shut down the system by using the halt command. After the storage system shuts down,the firmware boot environment prompt is displayed (Example A-14).Example A-14 Halting processn3300a*> haltCIFS local server is shutting down...waiting for CIFS shut down (^C aborts)...CIFS local server has shut down...Thu May 3 05:51:54 GMT [kern.shutdown:notice]: System shut down because : "halt".AMI BIOS8 Modular BIOSCopyright (C) 1985-2006, American Megatrends, Inc. All Rights ReservedPortions Copyright (C) 2006 Network Appliance, Inc. All Rights ReservedBIOS Version 3.0................Boot Loader version 1.3Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.Portions Copyright (C) 2002-2006 Network Appliance Inc.CPU Type: Mobile Intel(R) Celeron(R) CPU 2.20GHzLOADER>5. From the environmental prompt, you can update your firmware by using the update_flashcommand.6. At the firmware environment boot prompt, enter bye to reboot the system. The reboot usesthe new software and, if applicable, the new firmware (Example A-15).Example A-15 Rebooting the systemLOADER> byeAMI BIOS8 Modular BIOSCopyright (C) 1985-2006, American Megatrends, Inc. All Rights ReservedPortions Copyright (C) 2006 Network Appliance, Inc. All Rights ReservedBIOS Version 3.0..................7. Check the /etc/messages and sysconfig -v outputs to verify that the updates weresuccessful.Setting up the network using consoleThe easiest way to change network configuration is by using setup command. But the newcontents do not take effect until the filer is rebooted. This section addresses how to changethe network configuration without rebooting the filer.Restriction: In Data ONTAP 7.2 and later, disk firmware updates for RAID 4aggregates must complete before the new Data ONTAP version can finish booting.Storage system services are not available until the disk firmware update completes.
