IBM OPTIONS Zip 100MB IDE User Manual

If your computer has two IDE ports (one IDE cable on each port),you can attach up to four devices (two devices on each cable).Note: Not all cables have connections for two IDE devices.Mounting brackets and tools Most computers have 3.5-inch and 5.25-inch drive bays. TheZip IDE drive you are installing is designed for a 3.5-inch bay,but it can be adapted to a 5.25-inch bay. Common baydimensions are:– 3.5-inch—10.2 cm x 15.2 cm x 2.6 cm (4 in. x 6 in. x 1in.)– 5.25-inch—15.2 cm x 20.3 cm x 4.1 cm (6 in. x 8 in. x1.63 in.)You might need special mounting hardware for someinstallations. For more information on mounting a drive inyour computer, contact your dealer or refer to thedocumentation that comes with your computer. You will need a flat-blade and a Phillips-head screwdriver.Installing the DriveThe instructions in this section are general guidelines that apply tomost computers. For specific information on installing a drive in yourcomputer, see the documentation that comes with your computer.Step 1. Opening Your ComputerBefore opening your computer, complete the following steps:1. Turn off the computer and all attached devices.2. Unplug the cables from the power outlets for your computer andall attached devices.It is now safe to open your computer. Locate a vacant drive bay andremove the panel cover. For specific information about opening yourcomputer, see the documentation that comes with the computer.Step 2. Unpacking the DriveUse the following procedure to unpack and handle the drive. Toprevent damage and static-electricity discharge, limit handling to aminimum.1. Do not open the antistatic bag until you are ready to install thedrive. Static electricity can damage the drive and other computercomponents.2. Touch your hand and the inner conductive surface of the antistatic2-2 Zip 100MB IDE Internal Drive User’s GuideAll manuals and user guides at all-guides.com