Procedure1. On the ASMI Welcome pane, specify your user ID and password, and click Log In.2. In the navigation area, expand System Configuration > Service Indicators > Indicators by Locationcode.3. In the Location code field, type the location code of the FRU and click Continue.4. From the Identify indicator status list, select Off.5. Click Save settings.Deactivating the identify LED by using the ASMI when you do not know thelocation codeLearn how to deactivate the identify LED by using the Advanced System Management Interface (ASMI)when you do not know the location code.About this taskYou can turn off the identify indicators in each enclosure.To complete this operation, your authority level must be one of the following levels:v Administratorv Authorized service providerProcedure1. On the ASMI Welcome pane, specify your user ID and password, and click Log In.2. In the navigation area, expand System Configuration > Service Indicators > Enclosure Indicators.All servers and enclosures managed by the ASMI will be displayed.3. Select the server or enclosure that has the part to be replaced and click Continue. The location codeidentifiers are listed.4. Select the location code identifier and select Off.5. To save the changes made to the state of one or more FRU indicators, click Save settings.Deactivating a check log indicator (system information indicator) by using theASMIYou can deactivate a check log indicator (system information indicator) or logical partition check logindicator by using the ASMI.About this taskThe check log indicator provides a visual signal that the system as a whole requires attention or service.Each system has a single check log indicator. When an event occurs that either needs your intervention orthat of service and support, the check log indicator lights continuously. The check log indicator is turnedon when an entry is made in the error log of the service processor. The error entry is transmitted to theerror log file of the system and to the error log file of the operating system.To complete this operation, your authority level must be one of the following levels:v Administratorv Authorized service providerProcedure1. In the ASMI Welcome pane, specify your user ID and password, and click Log In.2. In the navigation area, expand System Configuration > Service Indicators > System InformationIndicator.Common procedures for removing or replacing the system processor module 79