IBM System x3250 User Manual

Also see for System x3250: Installation and user guide Installation guide Specifications Problem determination and service guide

Contents

Setup and configuration overviewWhen you use the ServerGuide Setup and Installation CD, you do not need setupdiskettes. You can use the CD to configure any supported IBM server model. Thesetup program provides a list of tasks that are required to set up your server model.On a server with a SAS/SATA controller with RAID capabilities, you can run the LSILogic Configuration Utility program to create logical drives.Note: Features and functions can vary slightly with different versions of theServerGuide program.When you start the ServerGuide Setup and Installation CD, the program promptsyou to complete the following tasks:v Select your language.v Select your keyboard layout and country.v View the overview to learn about ServerGuide features.v View the readme file to review installation tips for your operating system andadapter.v Start the operating-system installation. You will need your operating-system CD.Typical operating-system installationThe ServerGuide program can reduce the time it takes to install an operatingsystem. It provides the device drivers that are required for your hardware and forthe operating system that you are installing. This section describes a typicalServerGuide operating-system installation.Note: Features and functions can vary slightly with different versions of theServerGuide program.1. After you have completed the setup process, the operating-system installationprogram starts. (You will need your operating-system CD to complete theinstallation.)2. The ServerGuide program stores information about the server model, serviceprocessor, hard disk drive controllers, and network adapters. Then, the programchecks the CD for newer device drivers. This information is stored and thenpassed to the operating-system installation program.3. The ServerGuide program presents operating-system partition options that arebased on your operating-system selection and the installed hard disk drives.4. The ServerGuide program prompts you to insert your operating-system CD andrestart the server. At this point, the installation program for the operating systemtakes control to complete the installation.Installing your operating system without using ServerGuideIf you have already configured the server hardware and you are not using theServerGuide program to install your operating system, complete the following stepsto download the latest operating-system installation instructions from the IBM Website.Note: Changes are made periodically to the IBM Web site. The actual proceduremight vary slightly from what is described in this document.1. Go to http://www.ibm.com/servers/eserver/support/xseries/index.html.2. From the Hardware list, select System x3250 and click Go.3. Click the Install and use tab.Chapter 3. Configuring the server 37