106 IBM® xSeries 250: User’s Reference1800 A PCI adapter has requested a hardware interrupt that is not available.Action: 1. Make sure that the PCI adapter and all other adapters are set correctly in theConfiguration/Setup Utility program. If the interrupt resource settings are notcorrect, change the settings.2. If all interrupts are being used by other adapters, you might need to remove anadapter to make an interrupt available to the PCI adapter, or force other adapters toshare an interrupt.1962 No valid startup devices were found. The system cannot find the startup drive or operatingsystem.Action: Be sure that the drive you want to start from is in the startup sequence.1. Select Start Options from the Configuration/Setup Utility program main menu. Ifyou are unable to set the startup sequence, call for service.2. Check the list of startup devices in the Startup device data fields. Is the drive youwant to start from in the startup sequence?Yes Exit from this screen; then, select Exit Setup to exit theConfiguration/Setup menu. Go to step 3.No Follow the instructions on the screen to add the drive; then, save thechanges and exit the Configuration/Setup menu. Restart the server.3. Is an operating system installed?Yes Turn off the server. Go to step 4.No Install the operating system in your server; then, follow your operatingsystem instructions to shut down and restart the server.4. During server startup, watch for messages indicating a hardware problem.If the same error message appears, call for service.2400 An error occurred during the testing of the video controller on the system board. This error canbe caused by a failing monitor, a failing system board, or a failing video adapter (if one isinstalled).Action: Verify that the monitor is connected correctly to the video connector. If the monitor isconnected correctly, call for service.2462 A video memory configuration error occurred.Action: Make sure that the monitor cables are correctly and securely connected to the server.If the problem persists, call for service.5962 An IDE CD-ROM configuration error occurred.Action: Check the signal and power cable connections to the CD-ROM drive.If the problem persists, call for service.POST message DescriptionTable 16. POST error messages.
