64 IBM® xSeries 250: User’s Reference6. Remove the snap-on slide rails from the filler panel and snap the rails on thedrive. Store the filler panel for later use.Note: Slide rails for installing a tape drive are attached with screws. Use thescrews to attach the rails to the side of the tape drive.7. Align the slide rails on the drive with the guide rails in the bay; then, slide thedrive into the bay until it snaps into place.Note: If you are installing a tape drive, use the screws that are shipped next tothe tape drive rails to attach the tape drive to the front of the chassis.8. Disconnect the shuttle:a. Disengage the retaining levers by pressing inward.b. Move the retaining levers back to the unlocked position.c. Slide the shuttle toward the rear of the server until it stops.Note: It is not necessary to remove the shuttle from the server.9. If you are installing a SCSI device, continue with the next step. If you areinstalling an IDE device, go to step 11 on page 65.10. Install the two-drop SCSI cable:a. Locate the two-drop SCSI cable. This removable-media drive cable is locatedin the bottom of your server between the open bays and the power supplyarea. It is folded and restrained with a cable clamp.b. Connect one of the connectors on the two-drop SCSI cable to the back of thedrive.c. Connect the other end of the two-drop SCSI cable to the SCSI connector onthe power backplane.d. Go to step 12 on page 65.Retaining lever(unlocked position)
