IBM x3250 - System M3 - 4251 Installation And User Manual

Also see for System x3250: Installation guide User guide Specifications Problem determination and service guide

Contents

IBM x3250 - System M3 - 4251 Installation And User Manual Manual pdf 45 page image

v Do not allow your necktie or scarf to hang inside the server.v Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wristwatches.v Remove items from your shirt pocket, such as pens and pencils, that could fallinto the server as you lean over it.v Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,into the server.Handling static-sensitive devicesAttention: Static electricity can damage the server and other electronic devices.To avoid damage, keep static-sensitive devices in their static-protective packagesuntil you are ready to install them.To reduce the possibility of damage from electrostatic discharge, observe thefollowing precautions:v Limit your movement. Movement can cause static electricity to build up aroundyou.v The use of a grounding system is recommended. For example, wear anelectrostatic-discharge wrist strap, if one is available. Always use anelectrostatic-discharge wrist strap or other grounding system when working insidethe server with the power on.v Handle the device carefully, holding it by its edges or its frame.v Do not touch solder joints, pins, or exposed circuitry.v Do not leave the device where others can handle and damage it.v While the device is still in its static-protective package, touch it to an unpaintedmetal surface on the outside of the server for at least 2 seconds. This drainsstatic electricity from the package and from your body.v Remove the device from its package and install it directly into the server withoutsetting down the device. If it is necessary to set down the device, put it back intoits static-protective package. Do not place the device on the server cover or on ametal surface.v Take additional care when handling devices during cold weather. Heating reducesindoor humidity and increases static electricity.Removing the coverImportant: Before you install optional hardware, make sure that the server isworking correctly. Start the server, and make sure that the operating system starts,if an operating system is installed, or that a 19990305 error code is displayed,indicating that an operating system was not found but the server is otherwiseworking correctly. If the server is not working correctly, see the ProblemDetermination and Service Guide for diagnostic information.To remove the server cover, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 27.2. Turn off the server and peripheral devices and disconnect the power cords andall external cables, if necessary.Note: When you disconnect the power source from the server, you lose theability to view the LEDs because the LEDs are not lit when the powersource is removed. Before you disconnect the power source, make aChapter 2. Installing optional devices 29