ServeRAIDcontrollerMicroprocessorHeatsinkOrientationDIMMsDIMMsHard diskdrive backplaneHard disk drivebackplaneconfiguration cableSAS/SATA signalcable12. Take the signal cable that is attached to the drive backplane and connect it tothe connector on the ServeRAID-BR10il v2 SAS/SATA RAID adapter.Note: When you restart the server, you are prompted to import the existingRAID configuration to the new ServeRAID adapter.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 54.Installing an optional IBM ServeRAID-MR10i SAS/SATA ControllerYou can purchase an optional IBM ServeRAID-MR10i SAS/SATA controller. It canbe installed only in the dedicated slot on the riser-card assembly. For configurationinformation, see the ServeRAID documentation at http://www.ibm.com/systems/support/.Important: To ensure that any of your ServeRAID adapters function properly onUEFI-based servers, make sure that the adapter firmware level is updated to atleast 11.x.x-XXX, and the supporting drivers.Attention:v To ensure proper cooling and airflow, install a ServeRAID adapter that has abattery attached in slot 2 on the riser-card assembly.v Some cluster solutions require specific code levels or coordinated code updates.If the device is part of a cluster solution, verify that the latest level of code issupported for the cluster solution before you update the code.To install the IBM ServeRAID-MR10i SAS/SATA adapter, complete the followingsteps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 27.Chapter 2. Installing optional devices 47
