5. Touch the static-protective package that contains the new DVD drive to anyunpainted metal surface on the server; then, remove the DVD drive from thepackage and place it on a static-protective surface.6. Follow the instructions that come with the DVD drive to set any jumpers orswitches.7. Attach the drive retention clip (that comes with the DVD drive filler) to the sideof the new DVD drive.Alignment pinsDrive retention clip8. Align the drive in the drive bay and slide the drive into the DVD drive bay untilthe drive clicks into place.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 54.Replacing a PCI riser-card assemblyTo replace a PCI riser-card assembly, complete the following steps:1. Read the safety information that begins on page vii and the “Installationguidelines” on page 27.2. Turn off the server and peripheral devices and disconnect the power cords andall external cables.Note: When you disconnect the power source from the server, you lose theability to view the LEDs because the LEDs are not lit when the powersource is removed. Before you disconnect the power source, make anote of which LEDs are lit; then, see the Problem Determination andService Guide for information about how to solve the problem.3. Remove the cover (see “Removing the cover” on page 29).4. If an adapter is installed in the riser-card assembly, disconnect any cables thatare connected to the adapter.5. Grasp the front and rear of the riser-card assembly and lift it out of the PCIriser-card slot on the system board.Chapter 2. Installing optional devices 41
