alarmed because this is how the bezel was designed. The bezel is designedwith breakaway hinges so that you can easily reattach it to the chassis.Removing the side coverImportant: Before you install optional hardware, make sure that the server isworking correctly. Start the server, and make sure that the operating system starts,if an operating system is installed, or that a 19990305 error code is displayed,indicating that an operating system was not found but the server is otherwiseworking correctly. If the server is not working correctly, see the ProblemDetermination and Service Guide for diagnostic information.To remove the server side cover, complete the following steps:1. Read the safety information that begins on page v and “Installation guidelines”on page 22.2. Turn off the server and all attached devices (see “Turning off the server” onpage 16); then, disconnect all power cords and external cables.3. Unlock the side cover.4. Press the cover-release latch down (as indicated by the two arrows); then,remove the cover and set it aside.Left-side coverCover release latchLock5. Lift the side cover off the server and set it aside.To replace the side cover, see “Replacing the side cover” on page 70.Attention: For proper cooling and airflow, replace the cover before turning on theserver. Operating the server for extended periods of time (more than 30 minutes)with the cover removed might damage server components.26 System x3400 Types 7973, 7974, 7975, and 7976: User’s Guide