4. Repeat step 2 for the remaining hinge.Updating the server configurationWhen you start the server for the first time after you add or remove an internal orexternal device, you might receive a message that the configuration has changed.The Configuration/Setup Utility program starts automatically so that you can savethe new configuration settings. For more information, see the section aboutconfiguring the server in the User’s Guide on the IBM System x Documentation CD.Some optional devices have device drivers that you must install. See thedocumentation that comes with each device for information about installing devicedrivers.The server comes with at least one microprocessor. If more than onemicroprocessor is installed, the server can operate as a symmetric multiprocessing(SMP) server. You might have to upgrade the operating system to support SMP. Formore information, see the section about using the ServerGuide Setup andInstallation CD in the User’s Guide and the operating-system documentation.If the server has an optional RAID adapter and you have installed or removed ahard disk drive, see the documentation that comes with the RAID adapter forinformation about reconfiguring the disk arrays.If you have installed a Remote Supervisor Adapter II SlimLine to manage the serverremotely, see the Remote Supervisor Adapter II SlimLine User’s Guide, whichcomes with the adapter, for information about setting up, configuring, and using theadapter.For information about configuring the integrated Gigabit Ethernet controller, see theUser’s Guide.Chapter 2. Installing optional devices 33