ICP DAS USA I-7088 User Manual

Also see for I-7088: User manual

ICP DAS USA I-7088 User Manual Manual pdf 55 page image

I-7088I-7088 User Manual, Rev: A1.0 552.26. $AACnNSDescription:This command is used to set the synchronization status of aspecified channel.Syntax:$AACnN[CHKSUM](CR)$ Delimiter characterAA The address of the module to be set (00 to FF)Cn n specifies the channel to be setN The command to set PWM synchronizedS 0: Disables synchronization1: Enables synchronizationResponse:Valid Command: !AA[CHKSUM](CR)Invalid Command: ?AA[CHKSUM](CR)! Delimiter character for a valid command? Delimiter character for an invalid command(An invalid command is returned if the specifiedchannel is incorrect)AA The address of the responding module (00 to FF)There will be no response if the command syntax is incorrect,there is a communication error, or there is no module with thespecified address.Examples:Command: $01C0N1 Response: !01Sets the PWM channel 0 synchronization status to enabled.Command: $01C1N0 Response: !01Sets the PWM channel 1 synchronization status to disabled.Related Commands:Section 2.25 $AACnN, Section 2.32 $AAYS