M-7026M-7026 User Manual Rev: 1.5 Date: 2016/03/10 1482.72 @AARLDescription:This command is used to read the low latch values for all Analog Inputchannels of a specified module.Syntax:@AARL[CHKSUM](CR)@ Delimiter characterAA The address of the module to be read in hexadecimal format (00 toFF)RL The command to read the low latch values for all Analog InputchannelsResponse:Valid Command: !AA(Data)[CHKSUM](CR)Invalid Command: ?AA[CHKSUM](CR)! Delimiter character to indicate a valid command? Delimiter character to indicate an invalid commandAA The address of the responding module in hexadecimal format (00 toFF)(Data) The low latch values for all Analog Input channels. The data formatwill be the same as that set by the %AANNTTCCFF command(Section 2.1). See Section 1.9.4 for details of the data format.There will be no response if the command syntax is incorrect, there is acommunication error, or there is no module with the specified address.Examples:Command: @01RL Response: !01-02.000+00.000+00.000+00.000Reads the low latch values for all Analog Input channels of module 01and returns a response indicating that the command was successful, withthe data in Engineering Units format.Command: @01CL Response: !01Clears the low latch values for all Analog Input channels of module 01and returns a response indicating that the command was successful.Command: @01RH Response: !01+00.000+00.000+00.000+00.000Reads the low latch values from all Analog Input channels of module 01and returns a response indicating that the command was successful, withthe data in Engineering Units format signifying that the low latch valueshave been cleared.Related Commands:Section 2.1 %AANNTTCCFF, Section 2.57 @AACL, Section 2.59 @AACLi,Section 2.74 @AARLi
