 Chapter 3 Web Configuration PagePET-7000 DIO User Manual, May 2009, V1.00, EMH-013-10----------543.3. Authentication3.3.1. Account managementEach PET-7000 series module provides access privilege for up to five user accounts includinga default Admin account and four general user-defined accounts. Each of the user-definedaccounts can be assigned either Admin or general user privilege. Assigning Admin privilegeallows the account to read and write configuration settings but the general user account isrestricted to read only access. The maximum number of characters that can be used for anaccount name is 8.Each of the account requires password authentication. The maximum number of charactersallowed for the password is 8.Load Setup Defaults: Load the factory default Account management settings. All currentaccounts will be deleted, except the Admin account, and the password of Admin account willrevert to “Admin”.: Press this button to enable the settings to take effect.Notes:z The default account is “Admin” and the password is also “Admin”. Thepassword and the Admin account can be changed, but the account namecannot be changed or deleted.z If you forget the password for the Admin account, the ONLY way to configure theET-7000 is by using the “Reset to Factory default” option. (Please refer to LoadAll Setup Default on Sec. 3.2.3 for more information)

INTRODUCTION

F EATURES

S PECIFICATIONS

M ODULE S ELECTION

V IEW OF THE PET-7000

Table 1-2 LED Indicators

PET-7000 INSTALLATION

Connecting the Hardware

Ethernet cable wiring

Table 1-4 RJ-45 Wiring Standards

I/O WIRING CONNECTION

S OFTWARE & D OCUMENT INFORMATION

U PDATE I NFORMATION

CONFIGURING THE PET-7000

L OAD F ACTORY D EFAULT

WEB CONFIGURATION

O VERVIEW

C ONFIGURATION

Basic Settings

Table 3-2 Basic Settings

Table 3-3 Load All Setup Default Table

Module I/O settings

A UTHENTICATION

IP filter Settings

Web Editing

Table 3-4 Input or Holding Data Types

Web HMI

Table 3-6 Main Web HMI Page - Table 2

I/O P AIR C ONNECTION

M ORE I NFORMATION

HOW TO ACCESS THE PET-7000

U SING THE M ODBUS PROTOCOL

Function Codes Supported

I/O PAIR CONNECTION

SOFTWARE DEVELOPMENT APPLICATION

LabVIEW

OPC SERVER

P ROCEDURE FOR USING THE OPC SERVER

SCADA

C ITECT

iFix

TROUBLESHOOTING AND TECHNICAL SUPPORT

APPENDIX A: DIMENSIONS

APPENDIX B: MINIOS7 UTILITY

APPENDIX C: MODBUS REGISTER TABLES

APPENDIX E: JAVA INSTALLATION

APPENDIX F: FRAME GROUND

APPENDIX G: NODE INFORMATION AREA

APPENDIX H: TECHNICAL SUPPORT

ICP DAS USA PET-7060 User Manual

PET-7000 Series

PET-7060

PET-7067