WEB S ERVER CPU MODULE U SER ’S MANUAL FC9Y-B1278 3-53: I NSTALLATION AND WIRINGSecuring USB Extension Cable Using Cable TieWhen FC5A-D12K1E/S1E is installed in a control panel, it is possible to extend the USB Mini-B port of the PLC to the panelsurface using a USB extension cable (Note 1). When using the USB extension cable, it is recommended that the USBextension cable is secured to the USB port cover of the PLC using a cable tie (Note 2) so that the USB extension cable doesnot come loose from the USB port of the PLC. This section describes the procedure to secure the USB extension cable tothe USB port cover using the cable tie.Note 1: IDEC USB extension cable for USB Mini-B (HG9Z-XCE21) is recommended.Note 2: HellermanTyton cable tie T18R-1000 is recommended.1. Open the USB port cover and insert the USBextension cable into the USB port.2. Pass a cable tie around the USB cable cover and theUSB extension cable, taking care to route the cabletie through the notches on the USB cover.3. Insert the tip of the cable tie through the lockingsection to make a loop. Tighten the loop until it is thesuitable size and trim the excess cable tie using wirecutters.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
