3: INSTALLATION AND W IRING3-6 WEB S ERVER CPU MODULE U SER ’S M ANUAL FC9Y-B1278Mounting on DIN RailRemoving from DIN RailDirect Mounting on Panel Surface1. Fasten the DIN rail to a panel using screws firmly.2. Pull out the clamp from each Web server CPUmodule, and put the groove of the module on theDIN rail. Press the modules towards the DIN rail andpush in the clamps as shown on the right.3. Use BNL6 end clips on both sides of the Web serverCPU modules to prevent moving sideways.• Install the Web server CPU modules according to instructions described in this user’s manual. Improperinstallation will result in falling, failure, or malfunction of the Web server CPU module.• Mount the Web server CPU modules on a 35-mm-wide DIN rail or a panel surface.Applicable DIN rail: IDEC’s BAA1000PN10 or BAP1000PN10 (1000mm/39.4” long)CautionGroove35-mm-wide DIN RailClamp1. Insert a flat screwdriver into the slot in the clamp.2. Pull out the clamps from the modules.3. Turn the Web server CPU modules bottom out.35-mm-wide DIN RailClampWeb server CPU modules can also be mounted on apanel surface inside a console. When mounting a slimtype CPU module, digital I/O module, analog I/Omodule, HMI base module, or communication module,use optional direct mounting strip FC4A-PSP1P asdescribed below.Installing the Direct Mounting Strip1. Remove the clamp from the module by pushing theclamp inward.2. Insert the direct mounting strip into the slot wherethe clamp has been removed (A). Further insert thedirect mounting strip until the hook enters into therecess in the module (B).(B)(A)Direct Mounting StripFC4A-PSP1PPhone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
