Configuring IDEC SmartRelayIDEC SmartRelay Manual 2015.1.3 Modifying parametersYou first select the parameter you want to edit (see Chap-ter 5.1.2).You change the value of the parameter in the same way asyou did in programming mode:1. Move the cursor to the point at which you want to makethe change: Press or2. To change this value: Press ▲ or ▼3. To apply the value: OKNoteAlongside with a change of the time parameters when the systemis in RUN, you can also change the timebase (s = seconds, m =minutes, h = hours). This does not apply if the time parameter rep-resents the result of another function (for an example, see Chap-ter 4.4.1). In this case you can neither change the value nor thetimebase.The current time is reset to zero when you change the timebase.Current value of a time TView of a time T in parameter assignment mode:You can change the configured time T.▲▲B9Ta =06:00sT =80:00sChange: Press ▲ or ▼Move: Press orDone: OK▲▲B9Ta =06:00sT =80:00s Configured time TCurrent time T angineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.ste
