Programming IDEC SmartRelay78 IDEC SmartRelay Manual6. To move the cursor to the input of Q1, i.e. to B2, press :7. Confirm with OK.8. Now set the connector ‘x’ at output Q1 instead of blockB2. To do so:- Select the Co list: Press ▲ or ▼- Accept the Co list: Press OK- Select ‘x’: Press ▲ or ▼- Apply ‘x’: Press OKResult: Block B2 is deleted, because it is no longer used inthe circuit. This includes all blocks connected to B2. In thisexample, block B1 also.3.6.10 Correcting typing errorsProgramming errors can be corrected easily in IDEC Smart-Relay :• Provided editing mode is not yet closed, you can revert byone step by pressing ESC.• If you have already configured all inputs, simply reconfig-ure the faulty input:1. Move the cursor to the faulty position2. Change to editing mode. Press OK3. Enter the correct input circuit.You can only replace a block with a block that has exactly thesame number of inputs. However, you can delete the oldblock and then insert a new one. You can choose any newblock.▲B2 Q1ngineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.ste
