IDK HDC-UHD Series User Manual

Also see for HDC-RH221UHD: User guide Command reference guide

Contents

IDK HDC-UHD Series User Manual Manual pdf 72 page image

HDC-UHD Series User Guide729.8.2 Sink device EDID checkYou can set the sink device’s EDID checking mode.Menu C20 to C24: OUT1 to OUT5WEB menu OUTPUT SETTINGS → EDID ERR OUTPUT MODESetting value[Table 9.34] Sink device EDID checkSetting Front WEB browserIn case of EDID load error, the sink device is treated as a DVI device[Default]oFF OFFIn case of EDID load error, the sink device is treated as a HDMI devicewithout SCDCEr1 ERROR1Always treats sink device as a HDMI device without SCDC AL1 ALWAYS1In case of EDID load error, the sink device is treated as a HDMI devicewith SCDCEr2 ERROR2Always treats sink device as a HDMI device with SCDC AL2 ALWAYS2The HDC gets EDID from the sink device and determines if the sink device is an HDMI device or DVI devicein order to output HDMI signals. However, if the HDC cannot get EDID for some reasons, problems such asno audio output and the like may occur. In these cases, HDC recognized the connected sink device is HDMIor DVI device and output signal as HDMI or DVI mode depending on its setting.Notes:・ If setting this menu to a value other than the default (oFF, OFF), set “9.4.2 Resolution” to a supportedresolution other than “01” (External EDID).・ This setting is applied when HDMI signal is input and “9.8.3 Output format” is set to a format other thanDVI.【See: 9.8.3 Output format】