AFL-W10A-N270 User ManualPage 66BIOS SETUP UTILITYMain Advanced PCIPNP Boot Security Chipset Power ExitPrimary IDE MasterDevice :Not DetectedType [Auto]LBA/Large Mode [Auto]Block (Multi-Sector Transfer) [Auto]PIO Mode [Auto]DMA Mode [Auto]S.M.A.R.T. [Auto]32Bit Data Transfer [Enabled]Select the type of deviceconnected to the system Select Screen Select ItemEnter Go to SubScreenF1 General HelpF10 Save and ExitESC Exitv02.61 ©Copyright 1985-2006, American Megatrends, Inc.BIOS Menu 5: IDE Master and IDE Slave Configuration Auto-Detected Drive ParametersThe “grayed-out” items in the left frame are IDE disk drive parameters automaticallydetected from the firmware of the selected IDE disk drive. The drive parameters are listedas follows: Device: Lists the device type (e.g. hard disk, CD-ROM etc.) Type: Indicates the type of devices a user can manually select Vendor: Lists the device manufacturer Size: List the storage capacity of the device. LBA Mode: Indicates whether the LBA (Logical Block Addressing) is amethod of addressing data on a disk drive is supported or not. Block Mode: Block mode boosts IDE drive performance by increasing theamount of data transferred. Only 512 bytes of data can be transferred perinterrupt if block mode is not used. Block mode allows transfers of up to 64 KBper interrupt. PIO Mode: Indicates the PIO mode of the installed device. Async DMA: Indicates the highest Asynchronous DMA Mode that issupported. Ultra DMA: Indicates the highest Synchronous DMA Mode that is supported. S.M.A.R.T.: Indicates whether or not the Self-Monitoring Analysis andReporting Technology protocol is supported.
