AFL-W19A/W19B/17D/W15A-N270 Panel PCPage 513.3.2 IDE ConfigurationUse the IDE Configuration menu (BIOS Menu 4) to change and/or set the configurationof the IDE devices installed in the system.BIOS SETUP UTILITYMain Advanced PCIPNP Boot Security Chipset Power ExitIDE ConfigurationATA/IDE Configuration [Compatible]Legacy IDE Channels [SATA Pri, PATA Sec]Port2 SATA AHCI Speed: GEN 1 (1.5Gb/s)> Primary IDE Master : [Not Detected]> Primary IDE Slave : [ATAPI CDROM]> Secondary IDE Master : [Not Detected]> Secondary IDE Slave : [Not Detected]OptionsDisabledCompatibleEnhanced Select Screen Select ItemEnter Go to SubScreenF1 General HelpF10 Save and ExitESC Exitv02.61 ©Copyright 1985-2006, American Megatrends, Inc.BIOS Menu 4: IDE Configuration ATA/IDE Configuration [Compatible]Use the ATA/IDE Configuration option to configure the ATA/IDE controller. Disabled Disables the on-board ATA/IDE controller. Compatible D EFAULT The SATA drive is configured on an IDE channel. Enhanced Both IDE and SATA channels are configuredseparately. Legacy IDE Channels [SATA Pri, PATA Sec]Use the Legacy IDE Channels option to configure SATA devices as normal IDE devices. SATA Only Only SATA drives are on the IDE channels. IDE drivesare disabled SATA Pri,PATA SecD EFAULT SATA drives are configured on the Primary IDEchannel. IDE drives on the Secondary IDE channel