PCISA-MARK CPU Card4.5 Peripheral Device ConnectionCables provided by IEI that connect peripheral devices to the board are listed in Table4-1. Cables not included in the kit must be separately purchased.Quantity Type1 ATA 66/100 HDD cable1 Audio cable1 RS-232 cable1 KB/MS Y cable2 SATA cables1 SATA power cableTable 4-1: IEI Provided Cables4.5.1 IDE Disk Drive ConnectorsThe cable used to connect the CPU board to the IDE HDD is a standard 44-pin or 40-pinATA flat cable. To connect an IDE HDD to the motherboard, follow the instructions below.44-pin IDE cable connection is illustrated in Figure 4-2 and 40-pin cable connection isillustrated in Figure 4-3.Step 1:Step 2:Step 3:Step 4:Find the ATA 66/100 flat cable in the kit that came with the motherboard.Connect one end of the cable to the PIDE1 connector on the motherboard. Akeyed pin on the IDE connectors prevents it from being connected incorrectly.Locate the red wire on the other side of the cable that corresponds to the pin 1connector.Connect the other side of the cable to the HDD making sure that the pin 1 cablecorresponds to pin 1 on the connector.Step 0:Page 96 IEI® Technology, Corp.
