WSB-9452 PICMG 1.0 CPU CardPage 231D.2 RAID SetupD.2.1 IntroductionTo setup the RAID, the following procedures must be completed.Step 1: Two SATA drives, preferably with the same model and capacity, must beinstalled onto the system. Refer to Section 5.4.5.Step 2: The RAID BIOS must be configured.Step 0:D.2.2 Install SATA DrivesTo implement the on-chip RAID function, two SATA drives must be connected to thesystem. Use the SATA drive cables that came with the system to connect the SATA drives.Refer to Section 5.4.5.D.2.3 Configure the SATA Controller in BIOSTo configure the RAID BIOS, follow the steps below:Step 1: Turn on the motherboard and enter the BIOS setup utility. Do this by pressingD ELETE when the system boots up.Step 2: Select the Advanced Settings menus.Step 3: Select the IDE Configuration sub-menu.Step 4: In the IDE Configuration sub-menu, select the ATA/IDE Configuration option.Make sure it is set to the default setting [Compatible]. Keep the default setting ofthe Legacy IDE Channels option [SATA Pri, PATA Sec].Step 5: Select the Chipset menu.Step 6: Select the Southbridge sub-menu.Step 7: Set the SATA Controller Mode Select option to [RAID].Step 8: Press F10 to save the changes and exit the BIOS setup utility. Step 0:
