WAFER-GXPage 94Use the Boot Up Floppy Seek option to enable the BIOS to determine if the floppy diskdrive installed has 40 or 80 tracks during the POST. 360K FDDs have 40 tracks while760K, 1.2M and 1.44M FDDs all have 80 tracks.Î Disabled (Default) BIOS does not search for the type of FDD drive by tracknumber. Note that there is no warning message if thedrive installed is 360K.Î Enabled BIOS searches for a FDD to determine if it has 40 or 80tracks. Note that BIOS cannot tell the difference between720K, 1.2M or 1.44M drives as they all have 80 tracks.Î Boot Up Numlock Status [On]Use the Boot Up Numlock Status option to specify the default state of the numerickeypad.Î Off The keys on the keypad are not activated.Î On (Default) Activates the keys on the keypad.Î Gate A20 Option [Fast]Use the Gate A20 Option option to set if the keyboard controller or the chipset controlsthe Gate A20 switching.Î Normal The keyboard controller does the switching.Î Fast (Default) The chipset does the switching.Î Typematic Rate Setting [Disabled]Use the Typematic Rate Setting configuration option to specify if only one character isallowed to appear on the screen if a key is continuously held down. When this option isenabled, the BIOS reports as before, but it then waits a moment, and, if the key is still held
