WAFER-GXPage 83Use the Load Fail-Safe Defaults option to load failsafe default values for each BIOSparameter in the setup menus. Press F6 for this operation on any page.Î Load Optimized DefaultsUse the Load Optimized Defaults option to load optimal default values for each BIOSparameter in the setup menus. Press F7 for this operation on any page.Î Set Supervisor PasswordUse the Set Supervisor Password option to set the supervisor password. By default, nosupervisor password is set. To install a supervisor password, select this field and enter thepassword. After this option is selected, a red dialogue box appears with “EnterPassword: ”. Type the password and press ENTER. Retype the original password into the“Confirm Password: ” dialogue box and press ENTER. To disable the password, simplypress ENTER in the “Enter Password: ” dialogue box, then press any key in the“Password Disabled !!!” dialogue box.Î Set User PasswordUse the Set User Password option to set the supervisor password. By default no userpassword is set. To install a user password, select this field and enter the password. Afterthis option is selected, a red dialogue box appears with “Enter Password: ”. Type thepassword and press ENTER. Retype the original password into the “Confirm Password: ”dialogue box and press ENTER. To disable the password, simply press ENTER in the “EnterPassword: ” dialogue box, then press any key in the “Password Disabled !!!” dialoguebox.Î Save & Exit SetupUse the Save & Exit Setup option to save any configuration changes made and exit theBIOS menus.Î Exit Without Saving
