IKA C-MAG HS 4 digital Manual

Also see for C-MAG HS 10: Operating instructions Operating instructions Operating instructions Operating instructions Service manual

Contents

IKA C-MAG HS 4 digital Manual Manual pdf 2 page image

11PageDeclaration of conformity 4Safety instructions 11Unpack 12Correct use 12Setting operating modes 13Safe temperature limit 13Setting HI TEMP 13Warranty 13Commissioning 14Error codes 14Accessories 15Assembling the support rod 15Maintenance 15Technical data 16To your protection• Read the operating instructions in full before starting upand follow the safety instructions.• Keep the operating instructions in a place where they can beaccessed by everyone.• Ensure that only trained staff work with the appliance.• Follow the safety instructions, guidelines, occupational health andsafety and accident prevention regulations.• Socket must be earthed (protective ground contact).• Attention-Magnetism! Effects of the magnetic field have to betaken into account (e.g. data cardiac, carriers pacemakers...).• Risk of burns! Exercise caution when touching the housing parts andthe heating plate. The heating plate can reach temperatures in excessof 500 °C. Pay attention to the residual heat after switching off.• Please make sure that the mains cable does not contact the hea-ting plate.• Wear your personal protective equipment in accordance with thehazard category of the medium to be processed. Otherwise thereis a risk of:- splashing liquids- projectile parts- release any toxic or combustible gases.• Set up the appliance in a spacious area on an even, stable, clean,non-slip, dry and fireproof surface.• The feet of the appliance must be clean and undamaged.• Position the knob at the left stop before starting up. Graduallyincrease the speed.• Reduce the speed if- the medium splashes out of the vessel because the speed is toohigh- the appliance is not running smoothly- the container moves on the set-up surface.• Caution! Only process and heat up any media that has a flash pointhigher than the adjusted target temperature (0 to 500 °C) that hasbeen set.The target temperature must always be set to at least 25 °C lowerthan the fire point of the media used.• Check the appliance and accessories beforehand for damage eachtime you use them. Do not use damaged components.• Only replace damaged parts with spare parts identical to the origi-nal in function and quality.• Do not use the device if the ceramic set-up surface is damaged,e.g. scratches, splinters or corrosion. A damaged set-up surfacecould break if used.• Beware of the risk of- flammable materials- glass breakage- incorrect container size- too much medium- unsafe condition of container• Only process media that will not react dangerously to the extraenergy produced through processing. This also applies to any extraenergy produced in other ways, e.g. through light irradiation.• Process pathogenic materials only in closed vessels under a suitableContentsSafety instructionsEN