IKA C-MAG HS 4 digital Manual

Also see for C-MAG HS 10: Operating instructions Operating instructions Operating instructions Operating instructions Service manual

Contents

IKA C-MAG HS 4 digital Manual Manual pdf 3 page image

12extractor hood. Please contact IKA® if you have any questions.• Do not operate the appliance in explosive atmospheres, withhazardous substances or under water.• Please observe the operating instructions for any accessories used.• The socket for the mains cord must be easily accessible.• Ensure that the external temperature sensor PT 1000 is inserted inthe media to a depth of at least 20 mm.• The external temperature sensor PT 1000 must always be insertedin the media when connected.• The appliance can only be disconnected from the mains supply bypulling out the mains plug or the connector plug.• Safe operation is only guaranteed with the accessories describedin the ”Accessories” chapter.• Always disconnect the plug before fitting accessories.• Accessories must be securely attached to the device and cannotcome off by themselves. The center of gravity of the assemblymust lie within the set-up surface.• The appliance starts up again automatically following a cut in thepower supply (in operating mode B / C).• The appliance may heat up when in use.• Abrasion of the dispersion equipment or the rotating accessoriescan get into the medium you are working on.• When using PTFE-coated magnetic bars, the following has to benoted: Chemical reactions of PTFE occur in contact with molten ordissolved alkaline and alkaline - earth metals, as well as with fine-particled powders of metals of the 2. and 3. group of the periodi-cal system at temperatures above 300-400 °C. Only elementaryfluorine, chlorine trifluoride und alkaline metals do attack PTFE,halogen hydrocarbons have a reversibly swelling effect.Source: Römpps Chemie-Lexikon and “Ullmann“ Bd.19To the protection of the equipment• The appliance may only be opened by experts.• The voltage stated on the nameplate must correspond to themains voltage.• Do not cover the device, even partially e.g. with metallic plates orfilm. This results in overheating.• Protect the appliance and accessories from bumps and impacts.• Ensure that the base plate is kept clean.• Observe the minimum distances between devices, between thedevice and the wall and above the assembly (min. 800 mm).• Unpack- Please unpack the device carefully- In the case of any damage a fact report must be setimmediately (post, rail or forwarder)• Delivery scope- Heating magnetic stirrer - PT 1000- Mains cable - Operating instructions• Use- For mixing and/or heating liquids• Range of use- Laboratories - Schools - PharmaciesThis device is suitable for use in all areas except:- Residential areas- Areas that are connected directly to a low-voltage supply network thatalso supplies residential areas.The safety of the user cannot be guaranteed if the appliance is ope-rated with accessories that are not supplied or recommended by themanufacturer or if the appliance is operated improperly contrary to themanufacturer’s specifications.UnpackCorrect use