15Stirring organsstirring bars: Ø 6 mm, length to 15 mmØ 8 mm, length to 50 mmØ10 mm, length to 80 mmAny other accessoriesRSE stirring bar removerRS1 stirring bar setH15 bath topH28 bath topH16V support rodH38 holding rodH44 cross sleeveThe support rod is attached using the threaded support bore (H).• Screw nut M10 on to the support rod as far as the stop• Screw on the support rod as far as the stop by hand• Tighten the support rod and nut M10 using a flat wrench(SW17).• Use bossheads to assemble accessory parts oraccessory devices.Accessories17HThe appliance is maintenance-free.CleaningOnly use cleansing agents which have been recommended by IKA®.Use to remove:Dyes isopropyl alcoholConstruction materials water containing tenside/ isopropyl alcoholCosmetics water containing tenside/ isopropyl alcoholFoodstuffs water containing tensideFuels water containing tenside- Do not allow moisture to get into the appliance when cleaning- Wear protective gloves during cleaning the devices.- Before using another than the recommended method for clean-ing or decontamination, the user must ascertain with IKA® thatthis method does not destroy the instrument.Ordering spare partsWhen ordering spare parts, please give:- Machine type- Manufacturing number, see type plate- Item number and designation of the spare part, see www.ika.comRepairPlease only send devices in for repair that have been cleaned and are freeof materials which might present health hazards.For this, use the “certificate of compliance” form which you canobtain from IKA® or can download a version for printing from the IKA®website at www.ika.com.If your appliance requires repair, return it in its original packaging.Storage packaging is not sufficient when sending the device - also useappropriate transport packaging.MaintenanceAssembling the support rod