9 AfiMilk MPC Installation Manualo Press to confirm.o When done, press twice to exit editing mode.7.2.5 Adjusting the G and/or H parameter value via communicationThe easiest way to adjust G and H parameters values is via the AfiControl interface. Asexplained below, you may change the value of each milking point individually OR set auniform value to ALL the milk meters.To change the G and H values via AfiFarm PC enter Parameters➢Tools➢Parlor and selectthe stall to adjust as shown below.On the right hand side section of the screen, adjust the G and H values for the selectedstalls.
