Ice ADVENTURE SPRINT VORTEX Assembly Manual
                          | |
Contents
| 
172.14 Install the front derailleur cableThe front derailleur cable can be identified by the cable guide tube (chromed ‘noodle’). Pass the cable guideup through the rear (larger) hole on the underside of the front boom, so that it just pokes out of the hole on thetop face of the boom. NOTE – the “noodle” appears to sit at an odd angle but this is correct and angles thecable towards the derailleur.How the cable connects to the front derailleur will depend on the model fitted to your trike. Pull through anyslack cable. While holding the cable taut, turn the shifter through its range of movement to check the cablemoves smoothly and that the cable is properly seated inside the shifter. Run the cable under the cable anchorwasher and hold taut. Tighten the 5 mm hex cable anchor bolt to 5 Nm (44 in.lbs.). Be careful not to crush ordeform the cable.TIP - Do not trim any cables until you are happy with the varioussettings of front boom and gears. The loose end of the cable can betightly coiled so that it is out of the way. |
Related manuals for Ice ADVENTURE SPRINT VORTEX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine