Section 57FRONT PANEL PROGRAMMINGFront Panel Programming modeThe following settings can be changed in the FrontPanel Programming mode without a PC. This is a con-venient function to immediately change some settingswhen you operate the transceiver in the field.• Receive (RX) and Transmit (TX) frequencies• RX and TX CTCSS tone frequencies• RX and TX DTCS codes• Channel nameNOTE:While the transceiver is in the Front Panel Program-ming mode, you cannot receive or transmit.Entering the Front Panel ProgrammingDmodeRotateq [VOL] to turn OFF the transceiver.While holding downw [P0] and [UP], turn ON thetransceiver.• “SET MODE” is displayed.Pushe [P0] to enter the Front Panel Programmingmode.• A zone number and a channel number are displayed.To exit the Front Panel Programming mode and return tothe normal operation:Turn OFF the transceiver.➥Selecting a channel to programDAfter a zone and a channel number are displayed, asqdescribed to the left, push [P3] to enter the ChannelSelection mode.• The channel number blinks.Pushw [P1] several times to select a zone.Pushe [UP] or [DOWN] to select a channel you wantto program.Pushr [P3] again to set the channel.• The channel number stops blinking.zone channel