Icom IC-F4160DS Operating Manual

Also see for IC-F3162DS: Insrtuction manual Instruction manual Instruction manual Instruction manual

Contents

72 BIIS 1200 OPERATION■ Transmitting a callD General• Editing an IDIf the transceiver has a key assigned to the TX Code Enterfunction, you can edit an ID within the allowable digits.qPush [TX Code Enter] to enter the ID edit mode.• The digit to be edited blinks.wPush [TX Code Enter] to select a desired digit to be ed-ited.ePush [CH UP] or [CH DOWN] to select a desired number.rPush [TX Code Enter] to set. The digit to the right will au-tomatically blink.tRepeat step e and r to input all allowable digits.yAfter editing, push [TX Code Enter] to store the setting.• The transceiver returns to the standby mode.NOTE: To overwrite the original ID, set the ‘Update’ itemto “Enable” using the CS-F3160/F5060 (dPMR) cloningsoftware . Otherwise, changing the channel or turningOFF the transceiver discards the new ID, and returns theoriginal one. Ask your dealer for details.D Transmitting an Individual or Group callNOTE: If you want to make a call to the pre-programmedID, skip step q and w then directly go to step e.q Push [BIIS Button] to enter the call code memory mode.• The pre-programmed ID is displayed.• “ ” appears.w Push [CH Up] or [CH Down] to select a desired IndividualID or Group ID.e Push [Call] to make a call.• “WAIT” appears while transmitting.• “CONNECT” is displayed when an acknowledgement is received.NOTE: If no acknowledgement is received, the trans-ceiver automatically repeats the call three times (de-fault). However, when no acknowledgement is receivedafter each of the calls, an error beep sounds and“FAILED” is displayed. In that case, the transceiver au-tomatically returns to the stand-by mode.r After “CONNECT” is displayed, hold down [PTT] and speakinto the microphone at your normal voice level. Release[PTT] to receive.t After the communication is finished, push [Moni (Audi)] tosend a ‘Clear down’ signal to terminate the connection.BIIS CALL TXCE MON1234Appears