Icom IC-F4160DS Operating Manual

Also see for IC-F3162DS: Insrtuction manual Instruction manual Instruction manual Instruction manual

Contents

D For both BIIS 1200 and dPMR operationsThe following key functions are useful for BIIS 1200 and dPMRoperations.STATUS UP, STATUS DOWN “STUP” “STDN”➥ Push to select a status message.➥ When the automatic scroll function is activated, push tocancel it, if desired.➥ When an SDM that includes more than 12 characters isdisplayed, push to manually scroll the message.STATUS “STAT”➥ Push to enter the status message selection mode.• Push [CH Up] or [CH Down] to select a desired message.➥ Hold down for 1 second to transmit the last selected statusmessage.MESSAGE “MSG”➥ Push to enter the SDM selection mode.• Push [CH Up] or [CH Down] to select a desired SDM.➥ While in the SDM selection mode, hold down for 1 secondto transmit the last selected SDM.➥ While in the stand-by mode, hold down for 1 second toenter the message editing mode. (dPMR only)• Set a desired message using the 10-keypad. (Only 10-key version)(p.22)In BIIS 1200 operation, status messages and SDM areselectable in the same mode.D Additional key functions• For both BIIS 1200 and dPMR operationsThe following key functions are recommended for BIIS 1200and dPMR operations, and function as described below.CALL “CALL”➥ On an MSK channel, push to transmit a BIIS call.➥ On a digital channel, push to transmit a dPMR call.Depending on the pre-programmed settings, pushing [PTT]makes a call in the same way as using [Call]. Moreover,when you keep holding down [PTT] after receiving anacknowledgement, you can start a conversation withoutpushing it again.TX CODE ENTER “TXCE”Push to enter the ID code edit mode, and then set a desiredID code. (pp. 7, 18)• For only BIIS 1200 operationThe following key function is required for BIIS 1200 operation,and functions as described below.MONITOR (AUDIBLE) “MON”After communication is finished, push this key to send a ‘Cleardown’ signal to terminate the connection.Depending on the pre-programmed settings, the PriorityA channel is automatically selected after a ‘Clear down’signal terminates a connection.21PREPARATION12345678910111213141516