Icom IC-V85 Service Manual

Also see for IC-V85: Step-by-Step Programming Guide Instruction manual Service manual Instruction manual

Contents

3 - 1SECTION 3 DISASSEMBLY INSTRUCTION1. Removing the front panelq Remove the knob A and jack cap B.w Unscrew the Antenna nut and 4 screws C and D.e Disconnect the speaker connector.r Take off the chassis in the direction of the arrow.3. Removing shield plateq Unscrew 2 screws A.w Unsolder 2 points B, and remove the shield plate fromthe RF UNT.2. Removing the LOGIC UNITq Remove the rubber seal and dial nut.w Unscrew 5 screws A.e Disconnect the flat cable from J7.r Remove the LOGIC UNIT from the chassis in the directionof the arrow.Ant. nutFront panelSpeaker connectorChassisBCDAJ7Flat cableJack plateDial nutsealRubberLOGIC UNITA AAChassisShield plateRF UNITAB4. Removing the RF UNITq Unscrew 5 screws A.w Unsolder 4 points B (contact spring).e Unsolder 1 point C (antenna connector), and remove theRF UNIT from the chassis.RF UNITChassisBAAC