173 BIIS OPERATIONTransmitting a call■A total of 3 ways for code selection are available—selectingthe call code from memory, entering the call code from thekeypad and calling back from the queue channel record.Using call memoryD While in the standby condition, push [P1] (Digital) to enterqthe call code memory channel selection mode.• “ ” appears.C A L L I N G0 5 0 0AppearsPush [Up] or [Down], or rotate [DIAL] to select the desiredwcall code.Push [P0] (Call) or [PTT]* to call.e*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “WAIT” is displayed during each call. However, anerror beep sounds and “FAILED” is displayed when noanswer back is received after the calls.Push [PTT] to transmit; release to receive.rPush [P4] (Moni(Audi)) to send the ‘Clear down’ signal.tCalling back from the queue channelD While in the standby condition, push [P1] (Digital) for 1 sec.qto enter the queue memory channel selection mode.Push [Up] or [Down] or rotate [DIAL] to select the desiredwrecord.< Q U E U E >- Q U E U E ! -Push [P0] (Call) or [PTT]* to call.e*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “WAIT” is displayed during each call. However, anerror beep sounds and “FAILED” is displayed when noanswer back is received after the calls.Push [PTT] to transmit; release to receive.rPush [P4] (Moni(Audi)) to send the ‘Clear down’ signal.t