Icom MA-500TR Instruction Manual

Also see for MA-500TR: Instruction manual

Icom MA-500TR Instruction Manual Manual pdf 45 page image

377INSTALLATION AND CONNECTIONS12345678910111213141516■ ConnectionsAbout the installation distance from the compass:KEEP the transponder at least 1 m (3.3 ft) away from thevessel’s magnetic navigation compass.qtyrewq CLONING CABLE CONNECTORConnects the cloning cable from this connector to a PC.Ask your dealer for details.w INTERNAL GPS RECEIVER CONNECTORConnects to the MXG-5000 to receive position data andtransmit it with other AIS information.NOTE: Important notes and how to install the MXG-5000 are described on the instruction sheet that comeswith it. Be sure to read them before installing and oper-ating the MXG-5000.e DC POWER CONNECTORConnects the supplied DC power cable between this con-nector and a 12 V power source.r HIGH-DENSITY D-SUB 15 PIN (NMEA IN/OUT)Connects an Icom MarineCommander™ system, naviga-tion equipment, external GPS receiver, etc. using the sup-plied OPC-2014 nmea connector cable.See page 39 for the pin assignment.Requirements of the external GPS:• The datum of the external GPS receiver must be“WGS-84.”• GBS sentence can be input using the RAIM function.• The external GPS antenna must be installed within26 m (85.3 ft) of the internal GPS antenna.CAUTION: After connecting the DC power cable andNMEA connector cable leads, cover the cable and leadswith a rubber vulcanizing tape, to prevent water seepinginto the transponder.Rubber vulcanizing tape