103 MEMORY OPERATION Programming a memorychannelThis transceiver is equipped with 10 regular memory and 200group channels. You can program often-used frequencies intothem.q Rotate [DIAL] and [O-DIAL] to set the desired frequencyfor the standby frequency indicator.w Push [RCL] to enter the memory mode.• The channel number appears.• The memory channel name also appears if it has been entered.e Rotate [O-DIAL] to select the desired memory channeltype.• Select regular memory channel or group memory channel.r Push [MEM], and then rotate [O-DIAL] to select a “RE-PLACE” menu.• The memory channel number blinks.t Rotate [DIAL] to select a memory channel to be pro-grammed.y Push [MEM], then the selected memory channel is pro-grammed.• “WRITE COMPLETED” appears on the display when the regularmemory channel is programmed.u Push [RCL] to exit the memory mode. Channel selectionThe transceiver has 10 regular memory and 200 groupchannels (10 channels × 1 REGULAR MEMORY and 10channels × 20 GROUPS) for storage of often-usedfrequencies along with 6-character notes.q Push [RCL] to enter the memory mode.• The channel number appears.• The memory channel name also appears if it has been entered.w Rotate [O-DIAL] to select the memory channel type.• Select from regular memory channel or group memory channel.e Rotate [DIAL] to select the desired memory channel num-ber.Transferring the memory channel to the active fre-quency is necessary if operating at the memory chan-nel.Refer to “Transferring memory contents” (p. 12) for de-tails.r Push [RCL] to exit the memory mode.CH01127.005122.00RX MEMORY