Icom iC-F3033S Instruction Manual
Also see for iC-F3031S: Instruction manualService manual addendumInstruction manual
                                |
72 PANEL DESCRIPTIONTALK AROUND KEYPush to turn the talk around function ON and OFF.s 4HE TALK AROUND FUNCTION EQUALIZES THE TRANSMIT FREQUENCY TO THEreceive frequency for transceiver-to-transceiver communication.WIDE/NARROW KEYPush to toggle the IF bandwidth between wide and narrow.DTMF AUTODIAL KEY± Push to enter the DTMF channel selection mode. Then se-lect the desired DTMF channel using [CH Up]/[CH Down].± After selecting the desired DTMF channel, push this key totransmit the DTMF code.RE-DIAL KEYPush to transmit the last-transmitted DTMF code.CALL KEYSPush to transmit a 2-tone.s #ALL TRANSMISSION IS NECESSARY BEFORE YOU CALL ANOTHER STATION DE-pending on your signaling system.s ;#ALL != ANDOR ;#ALL "= MAY BE AVAILABLE WHEN YOUR SYSTEM EM-ploys selective ‘Individual/Group’ calls. Ask your dealer which callis assigned to each key.LONE WORKER KEYPush to turn the Lone Worker function ON or OFF.s )F THE ,ONE 7ORKER FUNCTION IS ACTIVATED THE %MERGENCY FUNCTIONis automatically turned ON after the specified time period haspassed with no operation is performed.TX CODE CHANNEL UP/DOWN KEYSPush to select a TX code channel directly.EMERGENCY KEYPush and hold to transmit the emergency call.s 4HE TRANSCEIVER CAN TRANSMIT THE EMERGENCY CALL SILENTLY OR AUDIBLYdepending on the presetting. Ask your dealer for details.s 7HEN THE EMERGENCY CALL TRANSMITS WITH BEEPS THE EMERGENCYtext is displayed on the LCD if programmed.s )F YOU WANT TO CANCEL THE EMERGENCY CALL PUSH AND HOLD THE KEYagain before transmitting the call.s 4HE EMERGENCY CALL IS TRANSMITTED ONE TIME ONLY OR REPEATEDLY UNTILreceiving a control code, depending on the presetting.SURVEILLANCE KEYPush to turn the surveillance function ON or OFF.When this function is turned ON, the beep is not emitted andthe LCD backlight does not light when a signal is received ora key is pushed, etc.TX CODE CHANNEL SELECT KEYPush to enter the ID code channel selection mode directly.Then set the desired channel using [CH Up]/[CH Down].(p. 11)USER SET MODE KEY± Push and hold for 1 second to enter user set mode.s $URING IN THE USER SET MODE PUSH THIS KEY TO SELECT AN ITEM THATis enabled by your dealer, and change the value or condition bypushing [CH Up] or [CH Down].± Push and hold this key for 1 second again to exit user setmode.User set mode is also available via the ‘Power ON function.’Refer to page 8 also. |
manualsdatabase
Your AI-powered manual search engine