Icom iC-F3161DT Instruction Manual

Also see for IC-F3161DT: Adjustment Instruction manual Instruction manual

Icom iC-F3161DT Instruction Manual Manual pdf 10 page image

52 PANEL DESCRIPTIONy BELL INDICATORAppears/blinks when the matched signal is received,according to the pre-programming.u CALL CODE MEMORY INDICATORAppears when the call code memory is selected.i BATTERY INDICATORAppears or blinks when the battery power decreases to aspecified level.IndicationFull Middle Chargingrequired No batteryBattery levelblinks when the battery is exhausted.blinks when the battery is over charged.o ALPHANUMERIC DISPLAY➥ Displays an operating channel number, channel name,Set mode contents, DTMF code, etc.➥ The indication mode can be selected from 1 line or 2lines. Ask your dealer for details.• In this instruction manual, the LCD illustration is describedusing the 2 lines indication mode.!0 KEY INDICATORIndicate the programmed function of the front panel keys([P0], [P1], [P2] and [P3]).■ Programmable function keysThe following functions can be assigned to [EMR], [Side1],[Side2], [Side3], [P0], [P1], [P2] and [P3] programmablefunction keys.Consult your Icom dealer or system operator for detailsconcerning your transceivers programming.If the programmable function names are bracketed in thefollowing explanations, the specific key is used to activate thefunction depends on the programming.CH UP AND DOWN KEYS “UP” “DOWN”➥ Push to select an operating channel. When [Rotaryselector] selects “operating channel,” this key is notavailable.➥ Push to select a transmit code channel after pushing[TX Code CH Select].➥ Push to select a DTMF channel after pushing [DTMFAutodial].➥ Push to select a scan group after pushing and holding[Scan].➥ Push to select the desired application type, individual/talkgroup ID, TX status message and SDM (Short DataMessage) after pushing [Digital Button].