Icom iC-F3161DT Instruction Manual

Also see for IC-F3161DT: Adjustment Instruction manual Instruction manual

Icom iC-F3161DT Instruction Manual Manual pdf 15 page image

103BASIC OPERATION12345678910111213141516■ Turning power ONPrior to using the transceiver for the first time, the batterypack must be fully charged for optimum life and operation.(p. 18)q Rotate [VOL] to turn the power ON.w If the transceiver is programmed for a start up password,input the digit codes as directed by your dealer.• 10-keypad can be used for password input depending onversion.• The keys in the table below can be used for password input.• The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are the same.KEYNUMBER 0549382716(Side1)P0 P1 P2 P3e When the “PASSWORD” indication does not clear afterinputting 6 digits, the input code number may be incorrect.Turn the power off and start over in this case.D Battery type selectionThe battery type must be selected according to the attachingbattery type when tuning the transceiver ON.➥ While pushing and holding [Emer] and [PTT], rotate [VOL]to toggle the attaching battery type.• After the display appears, release [Emer] and [PTT].• “ DRY BATT” is displayed for about 3 sec. then “Lo” (low powerindicator) appears when the battery case operation is selected.• “LI-ION” is displayed for about 3 sec. when the Lithium-ion bat-tery operation is selected.• This operation may not be available depending on the pre-setting.Ask your dealer for details.