Icom iC-F3161DT Instruction Manual

Also see for IC-F3161DT: Adjustment Instruction manual Instruction manual

Icom iC-F3161DT Instruction Manual Manual pdf 14 page image

2 PANEL DESCRIPTION9TX CODE CHANNEL SELECT KEY “TXC”Push to enter the TX code channel selection mode. Then setthe desired channel using [CH Up]/[CH Down]. (pp. 13, 14)TX CODE CHANNEL UP/DOWN KEYS “TXCU” “TXCD”Push to select a TX code channel directly.ID-MEMORY SELECT KEY “IDMS”➥ Recalls detected ID codes.• Push this key, then select the ID code using [CH Up]/[CHDown].• Up to 5 ID’s are memorized.➥ Push and hold for 1 sec. to erase the selected ID’s.SCRAMBLER/ENCRYPTION KEY “SCR”➥ While in the analog mode operation, push to toggle thevoice scrambler function ON and OFF.➥ While in the digital mode operation, push to toggle theencryption transmission function ON and OFF.COMPANDER KEY “COMP”Push to toggle the compander function ON and OFF.The compander function reduces noise components from thetransmitting audio to provide clear communication.USER SET MODE KEY “SET”➥ Push and hold for 1 sec. to enter user set mode.• During user set mode, push this key to select an item, andchange the value or condition using push [CH Up]/[CH Down].➥ Push and hold this key for 1 sec. again to exit user setmode.User set mode is also available via the ‘Power ON function.’Refer to page 15 also.OPT OUT KEYS “OP1” “OP2” “OP3”Push to control the output signal level from the optional unitconnector.OPT MOMENTARY KEYS “O1M” “O2M” “O3M”Push to control the output signal level from the optional unitconnector.