Icom ic-7300 Full Manual

Also see for IC-7300: Reference manual Basic Manual Service manual Basic Manual QUICK START OPERATING GUIDE

Contents

Icom ic-7300 Full Manual Manual pdf 135 page image

14-4MAINTENANCE14ResettingOccasionally, erroneous information may bedisplayed. This may be caused by static electricity orby other factors.If this problem occurs, turn OFF the transceiver. Afterwaiting a few seconds, turn ON the transceiver.If the problem still exists, perform a Partial reset asdescribed to the right.If the problem still exists after a Partial reset, performan All reset as described to the right.NOTE: An All reset clears all data and returns all settingsto their factory defaults. Save memory channel content,setting status, and so on, onto an SD card before the Allreset. (p. 8-4)After performing the partial resetA Partial reset resets operating settings to their defaultvalues (VFO frequency, VFO settings, menu contents)without clearing the items listed below:• Memory channel contents (Section 9)• MY Call (p. 13-5)• Memory Keyer (p. 4-19)• RTTY memory (p. 4-24)• User Band Edge (p. 3-7)• REF Adjust (p. 13-4)• Fixed Edges (p. 5-7)After performing the All resetAll reset clears all data and returns all settings to theirfactory defaults.Memory channel contents, filter setting and so onwill all be cleared, so you will need to rewrite youroperating settings, unless you have a backup.When you cannot enter the Set modeIf a touch screen operation error or an unexpectedoperation occurs, you cannot enter the Set mode. Inthat case, perform the All reset as described below:While holding down CLEAR and V/M , push POWER .D Partial reset1. Open the RESET screen.MENU » SET > Others > Reset2. Touch “Partial reset.”• The confirmation screen is displayed.3. Touch [Yes].L After the resetting, the default VFO mode screen isdisplayed.D All reset1. Open the RESET screen.MENU » SET > Others > Reset2. Touch “All reset.”• The confirmation screen is displayed.3. Touch [NEXT].4. After carefully reading the displayed message,touch [YES] to perform the All reset.L After the resetting, the default VFO mode screen isdisplayed.