Ideal Boilers LOGIC MAX HEAT H 18 Installation & Servicing

Also see for LOGIC MAX HEAT H 12: User guide

42Installation and ServicingSECTION 2 - INSTALLATION2.30 HANDING OVER6. Explain and demonstrate the function of time andtemperature controls, radiator valves etc., for the economicuse of the system.7. If a timer is fitted draw attention to the timer UsersInstructions and hand them to the householder.8. Explain Boiler restart procedure.9. After installation and commissioning please complete theBenchmark Commissioning Checklist before handover to thecustomer. For IE, its is necessary to complete a “Declaration ofConformity” to indicate compliance to I.S. 813:2002.IMPORTANT10. A comprehensive service should be carried out ANNUALLY.Stress the importance of regular servicing by a Gas SafeRegistered Engineer. In IE servicing work must be carried outby a Registered Gas Installer (RGII).11. Inform the householder of the guarantee/registration foundwithin the envelope pack and the requirement to register it toreceive the full benefit of the warranty.1. Hand the User Instructions to the householder andexplain his/her responsibilities under the relevant nationalregulations.2. Explain and demonstrate the lighting and shutting downprocedures.3. The operation of the boiler and the use and adjustment of allsystem controls should be fully explained to the householder,to ensure the greatest possible fuel economy consistent withthe household requirements of both heating and hot waterconsumption.Advise the User of the precautions necessary to preventdamage to the system and to the building, in the event of thesystem remaining inoperative during frosty conditions.4. Explain the function and the use of the boiler heatingcontrols.5. Explain the function of the boiler fault mode.Emphasise that if a fault is indicated refer to “Fault Codes” inthe User Guide.After completing the installation and commissioning of the system the installer should hand over to householder by thefollowing actions:2.29 ACCESSING THE INSTALLER MODETo access Installer Mode press the function button and “RESTART”Buttons together for more than 5s.1. The last 3 faults will be shownSee Section 4.1 for Fault Code descriptions2. “SL” will be shownTo run the burner at minimum rate press “RESTART”, otherwisepress the function button.3. “SH” will be shownTo run the burner at maximum rate press “RESTART”, otherwisepress the function button.4. “VF” will be shownpress the function button.5. “dU” will be shownpress the function button.6. “P1” will be shownPress the function button.7. “P7” will be shownPress the function button.8. “FL” will be shownThis feature is not required on this appliance. Press the functionbutton.9. “SE” will be shownThis feature is not required on this appliance. Press the functionbutton to exit.INSTALLATION