Ikegami HDK-55 Operation Manual

Also see for HDK-55: Brochure & specs

Contents

Ikegami HDK-55 Operation Manual Manual pdf 90 page image

5.1 Settings Using Switches on the Camera74 HDK-55 1206 VER1 (U)Adjusting Intercom PGM VolumeThe intercom PGM volume can be controlled on the rear or right side of the camera. Perform Steps 1 and 2 to control the volumeon the rear of the camera, and Steps 1, 3, and 4 to control on the right side of the camera.1 Use the INCOM-1 PGM-1/2 switch or INCOM-2 PGM-1/2 switch on the rear of the camera to select an intercomPGM line.2 Turn the INCOM-1 PGM-1/2 control knob and INCOM-2 PGM-1/2 control knob on the rear of the camera toadjust the volume.3 Set the INCOM FRONT VR SELECT switch on the rear of the camera to INCOM-1/2.4 Turn the INCOM PGM control knob on the right side of the camera to adjust the volume.CAUTION:Be sure to adjust the volume to the appropriate level while listening to sound through the headset.Selecting Shutter SpeedThere are two types of shutter: preset shutter with 6 different levels of shutter speed set in advance, and variable shutter for whichthe user can set the shutter speed to any speed.- Preset shutter : Select from 6 levels of shutter speed: 1/100, 1/120, 1/250, 1/500, 1/1000 and 1/2000.- Variable shutter : Set the suitable shutter speed within the following range.- 1/60.2 to 1/2040 seconds (scanning mode: 59.94Hz)- 1/50.2 to 1/2000 seconds (scanning mode: 50Hz)Variable Shutter function is effective when shooting a computer screen that is not synchronized with the normal TV frame rate,or a subject in quick motion such as the club swing of a golfer in order to playback in slow motion. With a faster shutter speed, ahigh-resolution picture can be shot without blur caused by the camera shaking when shooting subjects with vigorous movement, forexample a live coverage of a sporting event. However, the faster the shutter speed, the larger the interval between possible set valuebecomes.CAUTION:Setting from the camera is effective only for the self-contained system operation. When the camera is connected to the BS, set it fromthe control panels on the BS.Note:- The sensitivity decreases as the shutter speed increases. Ensure that the lighting condition is sufficient for faster shutter speedsettings.- When a remote controller is connected, the operation of the remote controller has priority over the operation switches on the camera(when SEMI REMOTE MODE is set to "OFF"). For details on how to operate the various remote controllers, refer to the instructionmanuals attached to the remote controllers.LENSMICP.FUNCONSELMENUOFFCHARVFPUSHSETCamera right view(Switch control panel)Camera front viewSHUTT/SUP-V switchRotary pulse switch