BM-141GE / BB-141GE64. Locations and Functions4.1. Locations and functions1. Lens mount C-mount (Note *1)2. CCD sensor 2/3 inch CCD sensor3. Flange back fixed screws Fix the ring after flange back adjustment4. 12-pin connector DC +12V power and GPIO interface5. D-sub 9 pin connector Auxiliary GPIO interface (LVDS IN and TTL IN/OUT)6. RJ-45 GigE Vision I/F. Accepts connector w thumbscrews.7. LED Indication for power and trigger8. LED GigE Network condition: LINK9. LED GigE Network condition: ACT10. Holes for RJ-45 thumbscrews Horizontal type (left and right of RJ-45) (Note *2)11. Holes for RJ-45 thumbscrews Vertical type (above and below RJ-45). (Note*2)12. Mounting holes M3 depth 5 mm for tripod mount plate (Note *3)*1) Note: Rear protrusion on C-mount lens must be less than 10.0mm.*2) Note: When an RJ-45 cable with thumbscrews is connected to the camera, please do notexcessively tighten screws by using a screwdriver. The RJ-45 receptacle on the cameramight be damaged.For security, the strength to tighten screws is less than 0.291 Newton meter (Nm).Tightening by hand is sufficient in order to achieve this.*3) Note: The tripod adapter plate MP-41 can be used with BM/BB-141GEFig. 1. LocationsLIN K A CT.D C IN/ TRIGGPIOPOWER/ TRIGGig E① ②③ ④⑤ ⑥⑦⑧⑨⑩⑪③⑫⑫
